Not quite the same as a sit of blob because those seem to be only for one layer. Not sure what is causing that.
You can set temps in Cura or do it the easy, faster way by editing the G-Code in NotePad.You might also want to turn fan settings down or completely off with PETG.The first several layers, your fan is off to help bond to the bed. Later layers I found fan setting is 100%I cut that back to 50% and seems to help a lot.I've had to also change my Z setting up a bit after self leveling. They say you shouldn't need to but sometimes you do!
OK. I can see this is gonna turn into a training course so maybe I'll start a new thread to make it easier for others to find.
No problem. I've talked to Matt and he agrees. Start a new thread about Cura settings, editing in Notepad, and other things I've learned. Then he said he'd make it a Sticky for future users.It would be better that way since many of the same issues are spread over many threads as it is now.
Well if a can change temps in Cura point me in that direction.
had my 1st fail most complicated part. came loose from the bed. any suggestions. pic attached, I think.