Dragon claw..sam yang

[Madd Hatter]

Talk to C.A.P. They're a advertiser here on GTA.

[Charly45]

Wanna try new hammer spring for now,probably get that aao kit when it gets cold...I can do it myself and says up to 350ftlbs...any body install one??
I've seen the vids on the cap but don't wanna send my rifle off to someone else..

[Madd Hatter]

Wanna try new hammer spring for now,probably get that aao kit when it gets cold...I can do it myself and says up to 350ftlbs...any body install one??
I've seen the vids on the cap but don't wanna send my rifle off to someone else..

Be ready for shipping sticker shock when ordering from AAO.

[c_m_shooter]

Morning all,
Just traded for a older sam yang claw in .50.
Gun is beautiful, well balanced and holds air great.did some open sighting in yesterday with some hunters supply 185g hps..at 30 yards can keep a 3 inch group. The trigger is actually  pretty decent at around 4 lbs I'd say...
My only concern so far is velocity.
I shot 18 rds.
Started at 560fps went to a hi of 635 at 10th shot and back down to 560 at 18th.
I seem to be overall weaker that it should be.
Looking for any info on what to check for?
Other than that fantastic rifle.

There are 2 notches when pulling the hammer.  Did you shoot it at half power?  If that is full power, then there is a problem with the hammer spring.

[Charly45]

Yes sir full power shot threwout...how much do you guys see the aao kits for? Says 275$ on there sight..
Will be trying new hammer spring when I can find one but still want to do the upgrade.
Thanx

[Charly45]

OK looking a little closer and found this oring not were it belongs,how much loss do you think this accounts for??
Still having trouble sourcing Orings and hammer spring..any ideas??
Thanx.
I still love the feel of this rifle.
Got some .498 round balls from track of the wolf and gained 20fps to 655...so getting there...very accurate also.

[Charly45]

Can I just remove just  the barrel or do I need to fully disassemble the gun to change this oring?

[maraudinglizard]

This video should get you to the barrel to replace the o-ring. There is some amount of disassembly to replace the o-ring.

[Madd Hatter]

Can I just remove just  the barrel or do I need to fully disassemble the gun to change this oring?

Because there's a transfer port between the barrel and the air tank you have to disassemble it. Just be very careful assembling the barrel to the transfer port. It's real easy to get it canted which will lead to air leaking and not actually pushing the projectile.