All Springer/NP/PCP Air Gun Discussion General > Share Your Simple Home Projects (TRICKS-N-TIPS)
Barrel Bending 101
mcoulter:
I posted a brief update here regarding how my Hatsan 135 is shooting after bending my barrel back:
http://www.gatewaytoairguns.org/GTA/index.php?topic=104942.msg998834#msg998834
lefteyeshot:
This morning the one piece mount came with one of my Hammers scopes fit the wide scope groves on my Slavia 631. Mounted the Hammers, leveled it, then centered it and it hit about 2 feet low at 25 yards. Adjusted till the elevation knob hit the top and it still hit real low. Re-centered the cross hairs and went to the tree fork by the fence. Took three trips to the tree fork then the gun was hitting 2" high and about 4" left. Zeroed from there. It's a nail driver now.
MicErs:
--- Quote from: ezman604 on July 14, 2013, 12:06:12 AM ---It's just too difficult for me to focus on the front sight, rear sight and the target. But the TruGlo sites on this airgun sure made a believer out of me.
--- End quote ---
You are not actually supposed to focus on the front sight, rear sight and target at the same time. Focus on the front site. Everything else will take care of itself.
Sfttailrdr46:
--- Quote from: MicErs on February 29, 2016, 07:09:29 PM ---
--- Quote from: ezman604 on July 14, 2013, 12:06:12 AM ---It's just too difficult for me to focus on the front sight, rear sight and the target. But the TruGlo sites on this airgun sure made a believer out of me.
--- End quote ---
You are not actually supposed to focus on the front sight, rear sight and target at the same time. Focus on the front site. Everything else will take care of itself.
--- End quote ---
;) ;) So that's what I've been doing wrong all these years ;D ;D
sawtoothscream:
Have to try this on my b 26. It shoots really high, had to adjust way to much to hit where I want and the poi shifts alot.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version