Donation

All Springer/NP/PCP Air Gun Discussion General > Big Bore AirGun Gate

Printed Stock for .257 Condor

(1/2) > >>

rsterne:
I just 3D printed a new stock for my .257 Condor....



The front of the stock fits inside the pistol grip and is glued to it (removable from the bottom with the original bolt).... The rear of the stock uses the stock tank clamp.... It is very rigid and the bottom is straight, flat, and parallel to the bore for shooting from the bench....

Bob

avator:
Looks pretty solid... nice job.

luge007:
Beautiful work Bob (as usual)  How is it holding up so far?

rsterne:
Haven't even shot it!....

Bob

cosmic:
Extend it to a widened fore grip and achieve one solid rifle...Just got a Texan LSS

Navigation

[0] Message Index

[#] Next page