Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Cura settings and G-Code editing

<< < (2/2)

brewbear:

--- Quote from: Insanity on October 16, 2022, 09:57:45 PM ---Thanks Jeff this is now a sticky.

--- End quote ---
Daaumm! I need new glasses! I was reading "this is now a stinky"...

Privateer:
Example files uploaded. It's a small washer that takes about a minute to print.
I included the STL and My G-Code settings from Cura.
I'll use those to show how easy it is to edit the G-Code in NotePad.
https://www.mediafire.com/file/wldvex0r7ld0cc2/Examples.zip/file

miksatx:
ok back and have the washer gcode file open in notepad.

Navigation

[0] Message Index

[*] Previous page