All Springer/NP/PCP Air Gun Discussion General > 3D printing and files
Filament splicing.
(1/1)
Insanity:
I always seem to have just enough left of a spool to not be as useful for a print. Seen one on amazon so I did some sleuthing and found a couple jigs to help in splicing the last of the old spool to the new one. There are a few versions available to print but I liked these ones the most.
https://www.thingiverse.com/thing:1052283
https://www.thingiverse.com/thing:2953445
Navigation
[0] Message Index
Go to full version