Quote from: precisionaction on June 11, 2021, 03:45:50 PMA new trigger issue has arisen, the trigger fully compresses, but the upper hook does not release. It feels like the trigger is sliding past the release. I have disassembled the rifle and inspected the trigger and did not find anything noticeably wrong.Any ideas.Your second stage screw has probably smoothed itself a little short.Screw the rear screw in the blade ½ turn and check if the second stage re-appears.Also mark the position of the screw in the trigger blade with a white China marker or other medium, SOME screws may back out with vibrations, but the most common case is the parts "wearing into each other" and ending up just a tad short.Keep us posted!
A new trigger issue has arisen, the trigger fully compresses, but the upper hook does not release. It feels like the trigger is sliding past the release. I have disassembled the rifle and inspected the trigger and did not find anything noticeably wrong.Any ideas.
Quote from: HectorMedina on June 11, 2021, 04:02:21 PMQuote from: precisionaction on June 11, 2021, 03:45:50 PMA new trigger issue has arisen, the trigger fully compresses, but the upper hook does not release. It feels like the trigger is sliding past the release. I have disassembled the rifle and inspected the trigger and did not find anything noticeably wrong.Any ideas.Your second stage screw has probably smoothed itself a little short.Screw the rear screw in the blade ½ turn and check if the second stage re-appears.Also mark the position of the screw in the trigger blade with a white China marker or other medium, SOME screws may back out with vibrations, but the most common case is the parts "wearing into each other" and ending up just a tad short.Keep us posted!After reading this, I remembered the stop clip on the end of the last/third screw (first stage travel weight) had popped off after sliding down the screw and went violently flying through the living room into oblivion. The event was quite comical, or at least I got a big kick out of it. I had a backup clip out of an assorted pack for various automotive repairs around the farm, and it was installed in less than ten. I adjusted it yesterday while bedding the rifle, and have been shooting ever since. -----------------------------------------------------------------------------------------Should I purchase 5.53mm pellets or 5.55mm pellets? I imagine one provides a tighter fit. Will this negatively affect my barrel?
Should I purchase 5.53mm pellets or 5.55mm pellets? I imagine one provides a tighter fit. Will this negatively affect my barrel?
I still have concerns over a noticed defect in the rifling of the barrel, that occurred after the first week of ownership. Saying this, I do not know what happened today, but all of a sudden the rifle really came into form. I started to hit my targets like I used to, and my groupings were tight again. I guess I must have finally thrashed the evil spirit out of it or something. Even later on, while shooting at silhouettes from 50yds, I couldn't miss.