GTA

All Springer/NP/PCP Air Gun Discussion General => 3D printing and files => Topic started by: Wolfdog91 on June 09, 2021, 11:12:27 PM

Title: Daisy 880 parts ?
Post by: Wolfdog91 on June 09, 2021, 11:12:27 PM
I don't know much about 3d printing but was curious if it would be possible for somone to 3D print the reciver and have it with a picatinny rail instead of a dove tail and possibly some way for it to have a stronger stock ?
Again I'm not very well informed about it but I see people 3d printing AR recovers so figured I'd ask.
Thanks
Title: Re: Daisy 880 parts ?
Post by: subscriber on June 16, 2021, 08:49:02 AM
Possible, yes.  However, unless one already has a 3D CAD model of the receiver, all the remaining original features would need to be designed.  That represents a significant amount of work. 

As getting one's hands on the factory 2D drawings seems unlikely, a receiver would need to measured very carefully, and all the features added to a 3D part model.  A slight shortcut could be 3D scanning the outside of the receiver as a starting point.

Designing some kind of Picatinny to dovetail adaptor that one can print and then attach to receiver seems like a lot less trouble.  You could even add 10 or 20 MOA drop compensation so the scope can live closer to mechanical zero.
Title: Re: Daisy 880 parts ?
Post by: Tdubya on October 15, 2021, 08:07:52 PM
There are dovetail to picatinny adapters.
Title: Re: Daisy 880 parts ?
Post by: subscriber on October 15, 2021, 10:40:07 PM
There are dovetail to picatinny adapters.

Yes there are.  The OP seemed eager to print something, a few moths ago.  In any event he seems to have lost interest in his own thread since then.  That seems like a prompt for me to unsubscribe from it.