Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Freecad 0.21.2

(1/21) > >>

Ronno6:
Where would I post questions/request guidance for using Freecad 0.21.2 ??

Anybody using/familiar with it?

nced:
Here are a couple tutorials.............



Hope this helps some!

Ronno6:
Thank you!
I'll give the second one a go.....
It is the first one I have seen for my version.
The earlier ones showed 2 rows of "Workbench" icons at the header...0.21.2 only has 1 row......

Time to learn!

Gramps-Too:
Search for Mango Jelly on YouTube has some really good tutorials https://youtube.com/@mangojellysolutions?si=BoQtLn0khl0DOmNH


Version 1.0 of Freecad has been released you might want to start with it if your just learning.

WobblyHand:
I'm still on FreeCAD 0.21.1 at the moment.  However, I have built 0.22dev (on a Mac, about 6 months ago) to help out a developer.  I can't imagine that 0.21.2 and 0.21.1 are that different, as that's a minor revision.  I use FreeCAD all the time.  Have no idea which forum/gate it would go under here at GTA.  If you have questions I'd be happy to try to answer them.

For very technical questions, you can post on their forum.  Just have to ask a decent quality question, and provide a working/non-working minimal model.  I've received some exceptional help from there, everything from modeling tips, to TechDraw, to FEA, up to CFD.

Navigation

[0] Message Index

[#] Next page