Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

.22 Marauder 32 mm OD x 140 mm LDCs - Direct shroud mount; and 1/2-20

<< < (2/6) > >>

subscriber:
This one is nicely done:

jolofree:
Yes that's it. I think I'll give that mod a try. Thanks!
And I cant srr sent messages, Did you receive my message about the shroud threads?
They are 8mm or .315" and virtually the same maybe one more thread in the shroud.
JF

subscriber:
John,

I just saw your PM about the shroud endcap thread length being 8 mm.  I have updated the moderator thread length and the thread test piece.  Version 2 STL print files with 8 mm long threads are attached below:

rualert:
     Hey Subscriber, toyed around with these for the Marauder Pistol yet? That could be quite useful as many have added an extension to reduce the report.

Casey

subscriber:
No, Casey, I have not.

Care to be more specific?

Navigation

[0] Message Index

[#] Next page

[*] Previous page