Donation

All Springer/NP/PCP Air Gun Discussion General > China/Asian AirGun Gate

Picked Up A Seneca Aspen Cheap

<< < (2/17) > >>

Madd Hatter:
Be careful,as that tube has a pressurized pre charge chamber. The pre charge can be relieved from the muzzle end of the tube.

Ronno6:

--- Quote from: Madd Hatter on September 27, 2023, 06:26:20 PM ---Be careful,as that tube has a pressurized pre charge chamber. The pre charge can be relieved from the muzzle end of the tube.

--- End quote ---


Thanks for that tip!

longhunter:
It's most likely the seal that goes around the outside of the prechamber.

Ronno6:

--- Quote from: longhunter on September 30, 2023, 11:22:58 AM ---It's most likely the seal that goes around the outside of the prechamber.

--- End quote ---

I would believe that to be the case.
I just gotta find the time and gumption to tear into it......

Pump function is also suspect.........it doesn't build much pressure, but I can't
tell anything til the leak is fixed.

longhunter:
If you're starting from empty, it'll take FOREVER  to build pressure.
To disassemble the pressure tube, remove the manometer, underneath you'll find a little flat bar. Remove it, under that is a pin. Push the pressure tube back to release the tension on that pin. Pull the pin with a small magnet. You can now slide the pressure tube out, without any further disassembly of the gun.
Be careful when you remove the tube. The poppet is directly behind it, will come flying out, if you're not careful.

Navigation

[0] Message Index

[#] Next page

[*] Previous page