All Springer/NP/PCP Air Gun Discussion General > 3D printing and files
Cura settings and G-Code editing
brewbear:
--- Quote from: Insanity on October 16, 2022, 09:57:45 PM ---Thanks Jeff this is now a sticky.
--- End quote ---
Daaumm! I need new glasses! I was reading "this is now a stinky"...
Privateer:
Example files uploaded. It's a small washer that takes about a minute to print.
I included the STL and My G-Code settings from Cura.
I'll use those to show how easy it is to edit the G-Code in NotePad.
https://www.mediafire.com/file/wldvex0r7ld0cc2/Examples.zip/file
miksatx:
ok back and have the washer gcode file open in notepad.
ray1377:
Unless I'm totally missing something. Is there a reason this thread just seemed to stop? The link to the g-code is now NOT there either. Did this thread get started somewhere else? Or get moved?
Ray
Insanity:
Loss of interest, time, and money to continue.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version