Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > 3D printing and files

Picitinny rear site rail for Diana Model 5

(1/2) > >>

miksatx:
Been trying to site in my model 5 iron site in at 15 ft. Been up and down and never come close to hitting in a 1" circle. So was thinking red dot on a picitinny rail. Anyone else think this might work?

Privateer:
So a rail you could bolt on where the site goes?

miksatx:

--- Quote from: Privateer on October 06, 2022, 12:12:04 AM ---So a rail you could bolt on where the site goes?

--- End quote ---
Yes that's what I was thinking. What it looks like under the site. Not very big screws holding it in place.

dan_house:
design the rail with the same diameter curve the compression tube has, and use a strip of _good_ double sided tape whne you screw it down.

Motorhead:
Easier ... Place a small extension on the FRONT site post. 
This will allow a Zero range shorter than site allows as it comes from manufacturer

Navigation

[0] Message Index

[#] Next page