Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > 3D printing and files

evanix rainstorm UL collapsible stock

(1/1)

Pitek:
just wanted to share my new setup. started out as a rainpup but the thing was so heavy so I came up with this (hopefully the pictures load). bare rifle to this in two days, I need to refine it a little bit before I upload the files.

Pitek:
had to do a lot of resizing to get the pictures to load....

dan_house:
Love it!

great work. how long does it take to print?

Insanity:
Thanks for sharing.

Pitek:

--- Quote from: dan_house on September 16, 2022, 05:28:44 PM ---Love it!

great work. how long does it take to print?

--- End quote ---

.2 layer, 80%infill, 10 shell layers, 50mm/s about 40 hours. that could be cut down depending on your printer speed and how much infill you want.

Navigation

[0] Message Index