All Springer/NP/PCP Air Gun Discussion General > 3D printing and files
Crosman rear sight plate
WhatUPSbox?:
I wanted to be able to adjust the notch width on the rear sight plate of the stock 13xx/22xx sight to account for barrel lengths and front blades. I also prefer a broader face on the plate.
As a 3D newbie, I used 3D Builder that comes with windows (I know, I need to get off the fence and pick a CAD program and pay the learning curve)
I posted a 1.8 mm notch model (though it prints smaller on my printer) and a blank without a notch. It is easy to edit in any size notch. I printed a whole range until I hit the goldilocks one.
I've printed it with and without supports, either way there was stuff to clean up on the backside of the wings. I sanded and painted the one in the picture.
Struckat:
Very nice, I like the green model.
Treeman63:
It looks good!
mafatone:
Cool!
dan_house:
if its printing “small” on yer printer, use the slicer to increase the size percentage 1/2% or so until it fits
cant tell from the pic, but if the wings arent the same thickness of the body, then make them the same thickness. then print it with the notch facing up, then you wont need supports
Navigation
[0] Message Index
[#] Next page
Go to full version