1
Back Room / Re: So....Whatcha Eating?« Last post by Xraycer on Today at 09:30:25 PM »Shrimp fried rice using original Banchan Japanese bbq sauce. Sooo goood!!!
2
Crosman-Benjamin Air Gun Gate / Re: Crosman 362 100 yr« Last post by Wimpod1 on Today at 09:11:32 PM »I ordered mine on the 5th of April using the code; CTYCN-6RG2C-XV3MJ provided in the Bargain gate. $239 to the door. After a few weeks delay due to stock levels, mine arrived today. Number 12xx out of 2300. She sure is pretty and yes I was able to slide the outer band off without breaking the seal. My grandson will be pleased if I hand this down to him.
3
Back Room / Re: Good morning! Are you up yet? What's your plans for today?« Last post by Madd Hatter on Today at 09:05:39 PM »😂😂😂Yes it did... under the watchful eye.Plans change quickly... well, at least they get interrupted quickly....Ok, the mower started did the lawn get mowed? 😜 I'm just channeling BL here.🤣🤣 5
Air Gun Gate / Re: Nova Freedom repair questions« Last post by SILENT SQUIRREL on Today at 08:49:11 PM »I'd say the.177 006 Orings need replacement. The.22 the pump side check valve is leaking.Thank you @Madd Hatter At some point this season I will get to at least one of them Edward 8
Welcome New Members / Re: Hello everyone!« Last post by AThomas on Today at 08:42:38 PM »Welcome to the GTA!
9
PCP/CO2/HPA Air Gun Gates "The Darkside" / Re: BSA R10 SE Air Leak« Last post by 100acres on Today at 08:41:47 PM »Well I finally got the time to give the gun a dunk in the tub. Sure enough it's leaking where the barrel shroud meets the receiver and a small amount out of the atmospheric vent holes. It's weird because I could never get a bubble out of soapy water in either place.
I ordered a reseal kit from AOA. The regulator looks easy enough to reseal so that's the direction I'm going this time. Next time I'll probably install the Huma regulator. This reseal job should be a fun little project. Thanks for all the suggestions guy! 10
3D printing and files / Re: TPU filament---need advice please« Last post by CK on Today at 08:34:12 PM »I've only played with Overture 95A in my Prusa MK4. I have not had jamming issues while printing. The only issues I have had was with tall prints messing up because of the flexing of the print. I use an EIBOS dryer along with it.
|