All Springer/NP/PCP Air Gun Discussion General > Vintage Air Gun Gate
Crosman 760 Rear Sight Screws Thread Size
(1/1)
newt68:
Anyone know the thread size of a Crosman 760 (4th Variant) Rear Sight screw? I bought this gun without a Rear Sight and plan on putting a scope on it. I would like to plug the holes in the barrel for the sight but don't know the thread size. Anyone here know?
Thanks
Goose:
--- Quote from: newt68 on September 19, 2022, 08:18:36 PM ---Anyone know the thread size of a Crosman 760 (4th Variant) Rear Sight screw? I bought this gun without a Rear Sight and plan on putting a scope on it. I would like to plug the holes in the barrel for the sight but don't know the thread size. Anyone here know?
Thanks
--- End quote ---
Have you thought about taking one down to the local hardware store? They should have something to match it.
Luck,
J~
newt68:
I did end up going to Home Depot and found some small set screws. Incase anyone is in the same boat the thread seems to be #6-32 and I think I will need a very small one like 3/32.
Navigation
[0] Message Index
Go to full version