Donation

All Springer/NP/PCP Air Gun Discussion General > China/Asian AirGun Gate

What is This?

<< < (2/6) > >>

stevemag:
Yup. I said  B3 to myself before I even clicked on it 😀

paddyfritz:
This photo should be a sticky.

Herman Green:

Interesting, but my B-3 has the hooded front sight as shown on the -1 and -2 but has the little lever in front of the trigger as shown on the -3.  I can't tell that the lever does anything other than make it harder to get your finger on the trigger.  It will fire with it in either position.  What's it supposed to do?

My stock has a split longways across the cheekpad.  Had it when I bought it new years ago.  Hasn't gotten worse yet and is functional.  I thought about filling it with epoxy.  Is there an inexpensive synthetic stock available anywhere that will fit this gun?

Thanks,

Herman

avator:
Herman;
I'm not surprised about your front sight being different at all. My B3-3 has a removable rear sight mounted on the rail grooves. The little lever in front of the trigger is the safety. Something may just be misaligned in the trigger group. I do know that some of the pins in the trigger group are held in place by the stock and if not careful, can fall out and become lost when the stock is removed. I bought a couple B3-4 guns from a wholesale site that had synthetic green camo stocks. I wouldn't know if they would fit or even where to get them. One suggestion would be to fill the crack in the stock with epoxy or putty then paint the stock with truck bedliner paint. It drys very hard and gives the finish a textured look.

dwalk:
IIRC it also has a leather piston seal... :-\ ???

Navigation

[0] Message Index

[#] Next page

[*] Previous page