All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

.22 Marauder 32 mm OD x 140 mm LDCs - Direct shroud mount; and 1/2-20

<< < (2/2)

This one is nicely done:

Yes that's it. I think I'll give that mod a try. Thanks!
And I cant srr sent messages, Did you receive my message about the shroud threads?
They are 8mm or .315" and virtually the same maybe one more thread in the shroud.


I just saw your PM about the shroud endcap thread length being 8 mm.  I have updated the moderator thread length and the thread test piece.  Version 2 STL print files with 8 mm long threads are attached below:


[0] Message Index

[*] Previous page

Go to full version
Powered by SMFPacks Media Embedder
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Ads Manager Mod