Subscriber, I think you mentioned going out past the end on the housing, can you design a moderator that extends past the front? More baffles, more quiet! I can drill the pin holes in a jig so see if you can put a band there or an open space where the cap inserts. Measurements coming in a few minutes of the whole interior of the housing...
my first complaint is the mickey mouse scope rail it flex's ..
i did not mount anything yet , just cleaned it yesterday, & noticed the plastic that the rail is on will move, i am going to mount lightweight discovery ffp sf 4x16x44 that i have laying around, it weighs just over 19 oz's.
Quote from: rdwilson on March 19, 2023, 06:03:04 PMi did not mount anything yet , just cleaned it yesterday, & noticed the plastic that the rail is on will move, i am going to mount lightweight discovery ffp sf 4x16x44 that i have laying around, it weighs just over 19 oz's.Honestly, I would return it and have them swap it out for a new one, I ran out and checked mine, took the scope off and moved the rail back and forth, all solid. You may have gotten one that has some slop. Sorry.
Quote from: Firewalker on March 19, 2023, 05:41:01 PMSubscriber, I think you mentioned going out past the end on the housing, can you design a moderator that extends past the front? More baffles, more quiet! I can drill the pin holes in a jig so see if you can put a band there or an open space where the cap inserts. Measurements coming in a few minutes of the whole interior of the housing...I sure can. Just need dimensions. Especially of interfaces that need to fit.
you're prints.
Quote from: subscriber on March 19, 2023, 05:42:53 PMQuote from: Firewalker on March 19, 2023, 05:41:01 PMSubscriber, I think you mentioned going out past the end on the housing, can you design a moderator that extends past the front? More baffles, more quiet! I can drill the pin holes in a jig so see if you can put a band there or an open space where the cap inserts. Measurements coming in a few minutes of the whole interior of the housing...I sure can. Just need dimensions. Especially of interfaces that need to fit.If you want to match the existing can OD, I need that too.
Measurements coming in a few minutes of the whole interior of the housing...
I will get to it this week sometime.
I guess that Notos must be fun for it to cause the small change in the probable timing of events suggested by the quotes below. It matters to me only because in a week or so I am going to become very distracted getting ready for an extended walkabout in the old country. At that point I won't be able to help anyone with anything.Quote from: Firewalker on March 19, 2023, 05:41:01 PMMeasurements coming in a few minutes of the whole interior of the housing...Quote from: Firewalker on March 19, 2023, 09:19:10 PM I will get to it this week sometime.
I love the escalating baffle depth You have designed!