Quote from: wll2506 on March 09, 2019, 10:41:05 PMOk I see the drawing but what does it mean, what angle where, you can't get to the angle in the barrel and you can't see where the port hole is in the barrel .... sorry I don't get it ?wllAll I did was use a dremel tool and put the cutting bit into hole in the top of the valve and cut out the side and bottom of the hole towards the middle of the valve ( I did not do anything to the barrel just the brass valve ). I just winged it, no measurements, just eye ball. The two pictures are an estimate of before and after.Please excuse my ignorance and unknown attempts working at modifying the air rifle.This is my first attempt at modifying one.Replaced drawing:
Ok I see the drawing but what does it mean, what angle where, you can't get to the angle in the barrel and you can't see where the port hole is in the barrel .... sorry I don't get it ?wll
Synthetic version of your airgun.
Looks like a little chunk of 12 gauge copper wire and you're in business.