I haven't spent alot of time with the gun. It is still in break in mode. It is getting a little easier but it still has a ways to go before I'm happy with it.
I really want this gun in .25.What is the barrel OD? How difficult would it be to use a NPXL barrel on this to make a .25?Also, is the dovetail under the rear sight base 3/8-11mm? I’d like to play with putting a red dot there.
Why not just drill out the plug that holds the hammer spring & hammer in the gun? Drill it, tap it to M8x1.25, install a 20mm bolt in the hole, and then you could pre-load the spring w/more less tension. Dont the PCP guns all do this?
Quote from: HPP-Mechanic on December 21, 2022, 12:46:03 AMWhy not just drill out the plug that holds the hammer spring & hammer in the gun? Drill it, tap it to M8x1.25, install a 20mm bolt in the hole, and then you could pre-load the spring w/more less tension. Dont the PCP guns all do this?There's a bolt that goes through that cap holding the upper receiver to the air tube
Quote from: Spacebus on December 21, 2022, 05:54:13 AMQuote from: HPP-Mechanic on December 21, 2022, 12:46:03 AMWhy not just drill out the plug that holds the hammer spring & hammer in the gun? Drill it, tap it to M8x1.25, install a 20mm bolt in the hole, and then you could pre-load the spring w/more less tension. Dont the PCP guns all do this?There's a bolt that goes through that cap holding the upper receiver to the air tubeYou're right. Maybe use 2 small screws from both sides to secure the cap & ditch the thru-bolt? I watched a youtube video where a guy ported the hi-pressure valve body w/carbide grinder on a Crosman pumper & got my head spinning...Where can I get spare parts for the Dragonfly2?