Donation

All Springer/NP/PCP Air Gun Discussion General > PCP/CO2/HPA Air Gun Gates "The Darkside"

Umarex Komplete Moderator removal

(1/4) > >>

Cage Kicker:
I bought the .22 version for my father in law and had it delivered here to my home so I could set it up for him.
 I installed a scope not the one that it came with and I took it out to zero it. Well it’s definitely not backyard friendly in its current condition.
I searched and searched for any guidance with no results so I decided what the heck and this how it went.

I degassed it and removed the action from the stock (hindsight I probably could have saved time by leaving it in the stock)

Removed the grub screw then I started turning the moderator by hand back and forth, it took quite a while to get it all the way off.

Once off I measured the outside diameter of the muzzle and then I went to  Donnyfl and ordered a slip on device 14mm to 1/2x20.
I plan on running a Fatboy.
I don’t know how to post pictures here and I’ll keep you updated once the slip on is delivered.

All this for him to control iguana’s at his sea wall.

ranchibi:
Warren, glad you WORKED that moderator off with some good ole fashioned effort! Hope the Fatboy quiets it down 👍. Happy New Year 🎈!

zackag:
Warren, I’m hoping to do the same with my komplete. How did the 14mm adapter work out?

Any pics of what the barrel looks like with the factory moderator removed?

Tigwelder85:
Hey cage kicker i have the same gun I was wondering if you could let me know the od of the actual barrel I’m gonna do the same thing and run a aftermarket moderator but was hoping I could just have my work thread the barrel any info is greatly appreciated

zackag:
I am assuming the OD is 14mm which is why cagekicker mentioned ordering that adapter. I ordered the same adapter and a donny Tanto hoping it will fit.

I am going to try the pull the moderator off in the next couple days before the parts get here. I’ll update with what I find.

Navigation

[0] Message Index

[#] Next page