Donation

All Springer/NP/PCP Air Gun Discussion General > PCP/CO2/HPA Air Gun Gates "The Darkside"

And so, it begins...

(1/19) > >>

JuryRigger:
A start... Not much, but a start...  ;)

Nothing fancy, going to be a simple Disco-style tube gun once all's done...
Progress will be slow, please be patient  ;)
Jesse

SADave:
Cool beans. Look forward to your progress

luge007:
AWESOME!  I'm sure it will turn out a functional work of art when done.

sb327:
Watching here, got any details on the valve?

Dave

JuryRigger:

--- Quote from: sb327 on March 08, 2024, 09:52:04 AM ---Watching here, got any details on the valve?

Dave

--- End quote ---
Thanks folks!

Valve is standard poppet style; albeit a bit cramped...  .125" stem (will be thinned down to .06" in the throat area), .19" porting, .2" throat... Valve body is bearing bronze, had scored this huge chunk of cored bar-so sawed a sliver out and turned it down... Valve spring is captive on a spigot turned into the rear of the body, the stem will be drill rod with a retaining nut for the spring... PEEK poppet, if I can get it to seal-my stem hole wandered off some when drilling-may end up remaking the valve...  :P

Gun will be based on a 3/4" OD .51" ID 1020 DOM tube I scored years ago, and a 7/16" Crosman lego barrel... The gage is going to be threaded into a small spud that will be welded to the main tube, also 1020 DOM... The upper isn't fully desgined yet, but will be a bolt-action repeater using a Hatsan Jet mag (that's the current plan at least LOL)....
Sort of a design-as-I-go thing...  ;)
Jesse

Navigation

[0] Message Index

[#] Next page