Quote from: Gertrude on June 01, 2017, 01:55:34 PMQuote from: rkr on June 01, 2017, 02:05:17 AMSo Evanix no longer has the o-ring groove in their valve stems? The Blizzard should have 4mm stem while my .45 Sniper has a 4.5mm stem, that might be a direct fit for Kral.Quote from: Flatpicker on June 01, 2017, 10:46:56 AM Thanks rkr! I've been shooting the PB alot lately and still enjoy it, but wish I could gain back those 30-40 ft/s that I had with the stock valve stem. The Sniper stem might be the answer.So has anyone here verified whether the stem for the Kral is the same dia., length, threads, as the stem for the Sniper ?Has anyone ordered a Sniper stem yet to find out ?I tried going the Blizzard route for a replacement lever that might fit, in the end after it was all said and done it didn't work out so I just ate the $$, it was tip money so it didn't hurt so bad, on this I'll wait on Troy to make up replacements, save myself the headache.
Quote from: rkr on June 01, 2017, 02:05:17 AMSo Evanix no longer has the o-ring groove in their valve stems? The Blizzard should have 4mm stem while my .45 Sniper has a 4.5mm stem, that might be a direct fit for Kral.Quote from: Flatpicker on June 01, 2017, 10:46:56 AM Thanks rkr! I've been shooting the PB alot lately and still enjoy it, but wish I could gain back those 30-40 ft/s that I had with the stock valve stem. The Sniper stem might be the answer.So has anyone here verified whether the stem for the Kral is the same dia., length, threads, as the stem for the Sniper ?Has anyone ordered a Sniper stem yet to find out ?
So Evanix no longer has the o-ring groove in their valve stems? The Blizzard should have 4mm stem while my .45 Sniper has a 4.5mm stem, that might be a direct fit for Kral.
Thanks rkr! I've been shooting the PB alot lately and still enjoy it, but wish I could gain back those 30-40 ft/s that I had with the stock valve stem. The Sniper stem might be the answer.
Well they do call it the "Breaker" sorry couldn't resist. I hope it turns out well.
The new stem is on the left. S7 drill rod. No o-ring groove. Shouldn't break.
Quote from: TroyHammer on June 02, 2017, 03:37:55 PMThe new stem is on the left. S7 drill rod. No o-ring groove. Shouldn't break.Did the original break on the o-ring or nearby. Is this the weak link on the valve stem. Wonder if the other Krals use the same stem. Thanks Troy.
Are you going to start making and selling these Troy?