Replace the screws in the trigger with longer 3mm hex screws and round the ends, this will give you some more adjustmentbut I could only reduce the pull weight to 3 lbs. So it seems the spring mod suggested will get you below 3 lbs.I found the trigger good with a clean break but was not a fan of the setback trigger blade
Quote from: mercury on December 15, 2018, 01:36:19 AMReplace the screws in the trigger with longer 3mm hex screws and round the ends, this will give you some more adjustmentbut I could only reduce the pull weight to 3 lbs. So it seems the spring mod suggested will get you below 3 lbs.I found the trigger good with a clean break but was not a fan of the setback trigger bladeOn the quattro trigger, when pulling the trigger try pulling up at an approx. 30Degree angle. It will reduce the felt pull weight quite a bit. Similarly, have your trigger finger rest on the trigger guard and follow its contour until shot releases. Hope this helps...
Thanks, Tom. Has the blade in that picture been shortened?
Jeff,Your picture was a big help. Worth a thousand words as the wise men say.... Would be even better if it could be simulated/animated!Again, gracias!