very nice wish I could get the barrel out of my 78g to rework the crown and leade but it's stuck in tight as tight can be
Installed LW 5mm (.20 cal) barrelInstalled Bomar rear sightMade custom valve pin, transfer port, and removable front sightmade steel picatinny rail dust hood cover/frame stiffener with transposed original serial number, parkerized and screwed to frameSerrated rear bolt face and Cerakotedmade paint filled scribe line on bolt release lever as visual lock-up indicatormade delrin spacer/insert fit to right side of bolt to eliminate axial bolt slopmade new bolt probe and stem to fully seat pellet skirt into rifling and facilitate use of a more robust narrower o-ringdeburred all casting flaws in frame and slide for Cerakote prep... Burnt Bronze frame and tan slideFashioned snug fit front sleeve with female champhered ends that center on male champhered adjuster housing and male champhered insert pressed into lower frame nose re-stamped frame to signify .20 cal revision replaced safety wording on frame (sanded flush) with red and white status dots on safety selectorfashioned full width (new frame cover width) trigger pin captured by 3-48 pan-head screw as opposed to splined trigger pin. Used .127" pin reducing trigger slop