Donation

All Springer/NP/PCP Air Gun Discussion General > Support Equipment For PCP/HPA/CO2

mlock rail backer ???

(1/2) > >>

Donnn3:
   
so I got the ati nova liberty ..synthetic stock... aka nova aspen syn ...aka SMK Nova Vista Alpha ... akaATI NOVA VISTA PCP ... very simular air ventu adventure ...syn stock

the front of stock only has a single mounting point .. a swivel .. ( dos not look very robust )  but does attach to barrel band...

... what I want ..looking for is what I believe is the mlock backer / backing plate . .. I want to add it to the stock over or next to the front swivel .. Im willing to carve out a little of the
   stock to add the plate inside the stock gluing it or epoxy or other so as to have two mounting points to the stock for a bipod mount...

... a 4 slot picatinny rail screwed to the swivel point and the point im willing to carve / glue should make a reasonablely tuff mounting ...

    so asking the brains that be here for the hardware needed  ( if you can undertstand my explaination )... or options .. but mostly hardware ..
   to emulate .. or actual mlock backer plate    allowing for to add the 4 slot pictinny rail that uses mlock attachment .... 

   as I am new to modifying this kind of stuff .. I may not be using the correct terms ... but the picatinny rail from amazon has  T nuts that are used to attach to Mlock point
   as I understand the description .. I want to add. that .to the inside of the stock .

... point fyi!!! the stock is hollow and opens up in two halves adding a plate to one side(glued?) should be enough to anchor plate across middle line allowing me to
     drill a hole in center line to add rail ...   

..thanks for the help.

Turbinator:

--- Quote ---or actual mlock backer plate    allowing for to add the 4 slot pictinny rail that uses mlock attachment ..
--- End quote ---

I think what you're looking for is something like this:

https://www.midwayusa.com/product/1020669686?pid=815473

There are several available at Midway USA, you attach this to the MLOK and it gives you a picatinny mounting point.  Thoughts?

Turby

Donnn3:
Turbinator  thanks ... but no...  thats what I have ... what i want is the part that the T-nuts grab on to ...  probabily looks like a square washer that the T nuts can grab ...

I was thinking I could glue (it / them) inside the thin plastic stock ( foregrip ) to add a two point attachment vs just the one ( swivel point ) ...

  FYI the picatinny I bought is a 5 slot ... .. one attatchment screw will go into the swivel location the other I want too make  ( thus the backer plate )   std Mlock  is just a slot

of a special size ... my foregrip is too thin alone wanted a plate with the same M Lock slot to glue inside my fore grip .... with a hole put where it needs to be for

the 5 slot picatinny rail .

Donnn3:

I need a piece that looks like whats inside the red circle ... or smaller .. just need one T-nut to attatch to it ...

Turbinator:
Now I follow you, sorry about not understanding at first.  Now I'm thinking you want something like this:



This isn't necessarily M-LOK compatible, but I do think from what you described, this is the sort of thing you're looking for.  You might need to machine out the slot a little more and figure out how to mount it, but I think this is heading in the right direction.  Thoughts?

Turby

Navigation

[0] Message Index

[#] Next page