All Springer/NP/PCP Air Gun Discussion General > Air Gun Gate
What airgun related did you do today?
Xraycer:
Got up at 4:30am to go to the gym before work. Sat on the throne. Checked out GTA on my cell phone.
AG72:
--- Quote from: Xraycer on September 20, 2018, 02:25:05 PM ---Got up at 4:30am to go to the gym before work. Sat on the throne. Checked out GTA on my cell phone.
--- End quote ---
Nothing like waking up and have to do a workout at the throne...
Xraycer:
--- Quote from: AG72 on September 20, 2018, 03:29:01 PM ---
--- Quote from: Xraycer on September 20, 2018, 02:25:05 PM ---Got up at 4:30am to go to the gym before work. Sat on the throne. Checked out GTA on my cell phone.
--- End quote ---
Nothing like waking up and have to do a workout at the throne...
--- End quote ---
Its like a religious ritual
Rico14:
I put an extra 30mm ring on my Hawke Sidewinder and set up the Side Shot scope cam so I can swap it between the .22 and .25
AG72:
Polished the ends off the spring for the Diana 350, have not done this to any of my guns but these was looking a bit rough so i did it, there are some deep cuts in them still but cant get them smooth with only sandpaper, or maybe i can but have not the patient to do it... Don't have the gun yet but it is only at 7.5 joule cause it's from germany so i have bought a spring and piston to get it up in power. Before and after images
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version