I don't have my 362 anymore but this 3622S stock does seem very familiar looking.
…but I still need a .22 probe…
Quote from: TennX on March 14, 2024, 03:45:26 PM …but I still need a .22 probe…In the US Mail, I thought you would have not already got it.
OK I finally got to shoot through the Chronograph today. but first I installed the steel breech and since I wanted a low power backyard friendly paper target gun, I took out the stock hammer spring and installed a 2240 hammer spring.First shot was 395. With each shot the fps slowly increased until I got to shot # 24, that's the first 500 plus fps shot. for the next 50 shots the rifle held in the 500 plus fps until shot #73 dropped below 500 fps. highest was 592 fps.Just what I was looking for!! next will be accuracy testing in the next couple days. With the LDC it is very quiet at the low fps I was getting. Total shots were 75 ending in the mid 400s. Was shooting JSB Jumbo 15.89 22 pellets. Not bad, 50 shots, need to find what pressure fill gets me 500 fps and only fill to that pressure.I can't load photos on my laptop right now or I would post the entire string.
Quote from: desertplinker on March 16, 2024, 05:33:31 PMOK I finally got to shoot through the Chronograph today. but first I installed the steel breech and since I wanted a low power backyard friendly paper target gun, I took out the stock hammer spring and installed a 2240 hammer spring.First shot was 395. With each shot the fps slowly increased until I got to shot # 24, that's the first 500 plus fps shot. for the next 50 shots the rifle held in the 500 plus fps until shot #73 dropped below 500 fps. highest was 592 fps.Just what I was looking for!! next will be accuracy testing in the next couple days. With the LDC it is very quiet at the low fps I was getting. Total shots were 75 ending in the mid 400s. Was shooting JSB Jumbo 15.89 22 pellets. Not bad, 50 shots, need to find what pressure fill gets me 500 fps and only fill to that pressure.I can't load photos on my laptop right now or I would post the entire string. for a nice flat shot string you can choke it at the transfer port rather than changing the hammer spring... I think the challenger t port is about .07" I am guessing that the 3622 t port is about .140 like the 13xx...
What’s the general consensus on power, is the 3622 putting out roughly the same as the 362 pump or is it slightly stronger in terms of FPS?