Quote from: Bob Pratl on February 13, 2019, 06:40:15 PMQuote from: msurf on February 13, 2019, 11:13:17 AMBob, I spoke with Jim and his recommendation was "You would need to mill the back of the magazine pocket for them to fit" Wondering if it is just the pocket that needs to be machined?The measurements that I took looks like it will fit the same as the .25 magazine after .062" is removed from the rear of the magazine pocket. Hopefully I will find out in the next couple of days.Bob Pratl ,I could be wrong but you may want to check and make sure that your bolt probe tip will have enough clearance once pulled all the way back for the magazine to cycle. Not looking at mine right now but if memory serves me right its pretty close. If it didnt clear then bolt probe would have to be shortened which then in turn wouldnt seat your bullet/pellet far enough past the barrel port. A sixteenth of an inch dont sound like much but sometimes it call make all the difference. Just saying,Chris
Quote from: msurf on February 13, 2019, 11:13:17 AMBob, I spoke with Jim and his recommendation was "You would need to mill the back of the magazine pocket for them to fit" Wondering if it is just the pocket that needs to be machined?The measurements that I took looks like it will fit the same as the .25 magazine after .062" is removed from the rear of the magazine pocket. Hopefully I will find out in the next couple of days.
Bob, I spoke with Jim and his recommendation was "You would need to mill the back of the magazine pocket for them to fit" Wondering if it is just the pocket that needs to be machined?