My other son just got an Ender 3 we were just looking at how the top 1/2 of the z has alot of movement, will check with him if he has investigated further as of yet. I had asked if there was a mod for fixing that, he had no clue at the time.
It's not bad and if you brick it boards are cheap.
m211 S0 inserted in the slicer at " start gcode" will unlock the Z height restriction.. ive printed as high as 450 mm on my ender , no issues and i didnt mod the firmware..
Quote from: Insanity on April 11, 2022, 03:55:51 PMIt's not bad and if you brick it boards are cheap.Could you provide a search term(s) for the board that would need to be replaced?