Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > 3D printing and files

LDCs that screw directly into the Airacuda Standard shroud

(1/12) > >>

subscriber:
The Standard Airacuda did not come with a 1/2 20 thread adaptor to its shroud.  GTA user Robert 5 mm asked if it would be possible to design him an LDC with a M22 x 1 mm male thread, that would screw into his Airacuda shroud directly.  Along the way, four variants were designed, in three different outside diameters: 1", 1.25" and 1.5".  All are 6" long.

The better performing three of the four designs are shown below.  Their STL files are attached in one zip file, below.

You can see photos of the 3D prints that GTA member TorqueMaster produced for Robert 5 mm, here:  https://www.gatewaytoairguns.org/GTA/index.php?topic=209670.0

oldpro:
 SLICK!!!!! Very nice work

oldpro:
 can you do a short fat one? Maybe 3 baffles and 1.75 OD?

subscriber:
Sure thing, Travis

How long would you like it?  3 or 4" ?

subscriber:
Fat LDCs create an opportunity to wrap a large primary blast chamber around what amounts to a 1" OD LDC.  In this case the design also happens to have a fat last baffle chamber.  I may do a more conventional design after this one, but this is what I was inspired to come up with.  STL attached inside zip file below.

The rear mounting shoulder to front face length is exactly 3.5".

Navigation

[0] Message Index

[#] Next page