Donation

All Springer/NP/PCP Air Gun Discussion General > PCP/CO2/HPA Air Gun Gates "The Darkside"

Advice On Keeping Or Getting A New PCP

<< < (2/5) > >>

Back_Roads:
 Here is a link to a digital manual, and EPV
https://www.pyramydair.com/airgun-resources/manuals/Gauntlet-Umarex-Manual.pdf

Eddie B:
First picture:  Air tank all the way in and will fire.
Second Picture:  Air tank backed off so shroud will go on.  All that is heard is the hammer clicking.

Eddie B:
Oh, so far, the bottle is holding air.

Eddie B:
Degas the bottle then took it off.  Screwed it back on all the way then turned it back just enough for the air gauge and fill nipple to clear the shroud.  As I was letting the hand pump cool, I noticed it was leaking air.  So, I repeated  each step and it's losing air again. Ugh!  What steps should be taken next?

kbstingwing:
have you tried putting some silicone lube on the Regulator O-rings, it may be that the surfaces are to dry or it may be a scratch on the inner surface of the drop block, try lubing the O-rings first with Silicone oil or Silicone grease.

Navigation

[0] Message Index

[#] Next page

[*] Previous page