Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > Support Equipment For PCP/HPA/CO2

Check Valves

<< < (2/3) > >>

3crows:
Thanks guys. I bought a cart at Harbor Freight today to set up the compressor and water container and filters and eventual bottle.

SILENT SQUIRREL:

--- Quote from: mikeyb on June 03, 2023, 11:46:31 AM ---Check valve should be in foster male. Lets air IN but not out.

Sometimes I use a slide vent (similar to link)  to depressurize the hose after filling so there are no surprise POPS when it's time to decouple the fosters.

https://www.alibaba.com/product-detail/Paintball-Air-Gun-Airsoft-PCP-Air_1600277991321.html

Same vent could be used OPEN to start the YH with zero back pressure and then CLOSED to build pressure and fill the bottle?

--- End quote ---
That looks like  a very useful valve
I could be wrong (nothing new),but it appears as if you need to buy at least 101.
Have you found a way to buy fewer than that @mikeyb?

Ed

Firewalker:
Here is mine:

3crows:


--- Quote from: SILENT SQUIRREL on June 04, 2023, 12:35:54 PM ---
That looks like  a very useful valve
I could be wrong (nothing new),but it appears as if you need to buy at least 101.
Have you found a way to buy fewer than that @mikeyb?

Ed

--- End quote ---




You can get them here on eBay:

https://www.ebay.com/itm/Paintball-PCP-Airsoft-Coil-Remote-Hose-Slide-Check-With-Quick-Disconect-Steel-/164585905552

SILENT SQUIRREL:
Thanks @3crows
I just bought one to try out
Edward

Navigation

[0] Message Index

[#] Next page

[*] Previous page