Donation

All Springer/NP/PCP Air Gun Discussion General > Machine Shop Talk & AG Parts Machining

Semi retired machinist looking for side jobs.

<< < (11/12) > >>

IOWOLF:
Please, send me a drawing, P.M. or. email.

2A Georgia:
If you fabricate a Hammer spring cover/endplate with the pre-drilled and tapped hole you could sell it as a kit: Challenger Standard to (better than) FX poor man's conversion kit.  I followed that thread but am not as good a machinist as James and shied away from drilling into my endplate...

Back_Roads:
 My busy work season here along with hunting on the way, I will make an attempt to take the H.S. adjuster out and make a detailed drawing ASAP.

IOWOLF:
As it is winter time and don't shoot as much....I am bumping this up.

If You have a project, I would look at it, send me a PM and a drawing.

2A Georgia:
Good sir, you fixed my AEA Challenger Seer several months ago.
Well I have sheared the driveshaft of my GXPumps CS-1.
No joy from the manufacturer on parts so wondering if you could machine a replacement?
The diameter is .4426 if I'm reading my micrometer correctly.
Please PM initial estimate or further details.  Many thanks!
I can ship you the two pieces shown in the photo if needed for estimating.

Navigation

[0] Message Index

[#] Next page

[*] Previous page