All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Cura settings and G-Code editing

<< < (2/3) > >>


--- Quote from: Insanity on October 16, 2022, 09:57:45 PM ---Thanks Jeff this is now a sticky.

--- End quote ---
Daaumm! I need new glasses! I was reading "this is now a stinky"...

Example files uploaded. It's a small washer that takes about a minute to print.
I included the STL and My G-Code settings from Cura.
I'll use those to show how easy it is to edit the G-Code in NotePad.

ok back and have the washer gcode file open in notepad.

Unless I'm totally missing something. Is there a reason this thread just seemed to stop? The link to the g-code is now NOT there either. Did this thread get started somewhere else? Or get moved?


Loss of interest, time, and money to continue.


[0] Message Index

[#] Next page

[*] Previous page

Go to full version
Powered by SMFPacks Media Embedder
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Ads Manager Mod