Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > 3D printing and files

Gonna build an enclosure

<< < (3/4) > >>

Privateer:
Moved stuff so I could get the table nearer the shelf, then used WMSD (Weapons of Mass Spider Destruction) all over the basement.
I'll do a good vaccum job and then start setting up the cover. It's an old canopy. Still checking for some parts for it.

WhatUPSbox?:

--- Quote from: Privateer on September 25, 2022, 03:36:12 PM ---used WMSD (Weapons of Mass Spider Destruction) all over the basement.


--- End quote ---

Well, since spider silk is stronger than steel, my question would be, how did it print? Maybe a new profile in CURA and a well fed spider farm may be the way to go.

Privateer:
That may not be as far fetched as one may think.
2010. Goats were breed that produce Spider silk.
2015. Spiders exposed to carbon nanotubes and graphene produced a silk roughly 3 times stronger. Producing a silk stronger than any known fiber.

daveb59:
1 of my printers is a makergear M2, had built an enclosure turned out to heavy. Was at dump and noticed a few college type fridges. Brought one home. Had to take the liner/plastic ot. Cut down the insulation. Cut and opening in the door and ad plexiglass. Going to ad same thing to side towards desk. Filament in a sealed container and drilled thru top and add some connectors so filament feeds to both hotends without be open to any air. Added 12v power supply in back for lights, fans, cameras and PI. Still not finished.

My Saturn resin just built a box with door and lift top.

Privateer:
Nice David! Pump up your post count and give us some pictures if you will.

My table is large enough for 3 printers easy. Maybe 4.
I want to just do a single cover for the whole area.

Navigation

[0] Message Index

[#] Next page

[*] Previous page