Donation

All Springer/NP/PCP Air Gun Discussion General > Big Bore AirGun Gate

B&W S45 AEA .457 six shot

(1/4) > >>

tkerrigan:
 I got one of these yesterday.  I can only get 2 bullets in the magazines.  The spring is fairly stout and only has six coils and is just bigger than the central shaft it wraps around, I can only turn it half a turn, unlike a marauder where the coils are close to the walls of the well that goes over the spring.  I also cannot figure out how to decock the gun without letting all the air out.  If anybody can help me out with these two problems I would appreciate it.  I sent an email to Bintac but haven't received a reply yet.  Regards, Tom

magicmatt:
If you can watch you tube videos from sig shooter that’s (bintac) or mr hollow point they have good videos on that platform.

cosmic:
Check Bin-Tac here...

tkerrigan:
As you can see the spring is wrapped pretty tightly around the post, about 1/2 turn is all you get.  The spring sitting inside the well has some extra room so the diameter could be bigger giving more clearance on the post.  Look how heavy that spring is.  It has six coils and I think there is clearance to have seven coils maybe with just a bit smaller wire.  Regards, Tom

cosmic:
Looks like Bin-Tac was having a difficult time winding it..

Navigation

[0] Message Index

[#] Next page