Donation

All Springer/NP/PCP Air Gun Discussion General > Show Off Your Air Guns With Mods (SHOW and TELL)

ADDING A PRESSURE GAUGE where one did not exist before .... it can be done !

<< < (2/2)

DIAMOND:
I love stuff like this.

Reminds me of when I was a kid. I drilled a hole in a 20 gram CO2 cartridge and tapped it and screwed in a quick release connector.

I hooked up my dad's air compressor and let it charge up.

I learned 120 psi was not enough pressure. But it was a fun project!  8)

DLP:
Nice. Similar to what I did with my Badger.  But yours does look a lot cleaner. Why anyone would build a pcp without a fill gauge is beyond me. Especially on a bigbore that has a very thin useable fill pressure margin. Then add freezing temps. While deer hunting below 0*, I was always worried where I was at on a fill.

woogie_man:
Surprising that the Thomas doesn't have a gauge on the rifle?

Looks clean and a good way to hide a customized part on the rifle. Really looks factory

Navigation

[0] Message Index

[*] Previous page