For some time I have been wondering how effective the SSG would be on a CO2 gun like the Crosman 2260.... I had the opportunity to try that out today.... The testing started out with the gun configured exactly as a stock 2260.... Stock valve, hammer and spring, stock transfer and barrel ports, and a 24" barrel, although the gun did have a Crosman steel breech on it.... I loaded a brand new 12 gr. CO2 cartridge, fired the gun twice to pierce the cartridge, and then shot a string using 18.1 gr. JSB Heavy pellets until the velocity dropped to 300 fps, at which point I stopped.... I fired one shot every 30 seconds, and the temperature was 68*F.... I then repeated the testing using a much lightened hammer that was 50% of the weight of a stock one.... In both cases the stock rear cap was in place, so the preload on the 2260 spring was completely stock.... I then fitted an SSG, using the same spring, with as much preload I could use and still cock the gun with no gap between the end of the guide and the hammer.... I adjusted the gap to 0.020", installed a new cartridge, fired two shots to pierce it, and then fired another string.... The results are shown in the graph below....There are some interesting things to note.... In stock form, even though I was only shooting every 30 seconds to limit cooling, the velocity declined in a near linear fashion for 30 shots, and then dropped rapidly, with a total of 37 shots above 300 fps.... I calculated the FPE of every shot and added them up, getting a total of 341 FPE from a 12 gr. cartridge.... With the lighter hammer, the initial velocity was lower, but within 15 shots it leveled off, staying within a very narrow ES for another 30 shots before dropping, with a total of 53 shots above 300 fps.... The total FPE from that cartridge was 457 FPE, which is pretty good, and a 34% improvement over stock.... With the light hammer and the SSG, the velocity stabilized quite quickly, and I got over 60 shots before it started to decline.... and the initial decline was not as dramatic.... and I got a total of 78 shots above 30 fps.... over twice as many as stock.... The total FPE from a cartridge with the SSG fitted was 627 FPE, breaking my own previous record of 608 FPE with an 18" barreled 1750.... That represents 84% more energy from a 12 gr. than I got stock....I am extremely pleased with the huge increase in FPE per 12 gr. CO2 obtained by using the SSG.... This was, additionally, the first attempt using an SSG on a CO2 gun for me, and breaking the 600 FPE mark without tuning was pretty impressive.... I look forward to trying some different settings to see if I can get even more energy from a 12 gr. in the future.... but right off the bat, we know it works great on CO2....Bob
Hey everyone!I just finished setting up an SSG and testing for Mr. Sterne's Leap Year Challenge and thought I'd start a thread where people can post results and questions regarding setting up a SSG for the 22xx platforms.I just copied and pasted my entry from the challenge thread to get things started. I was going for the most efficient tune I could get, I wasn't going for power. Going forward I hope we can use each others information to get the setup we each are looking for.Here are my results (after many tweaks and even more strings run).The only thing I used that didn't come with the 2240 was the TKO and the SSG unit that I made for testing (and some white paint on the grips but they ARE the stock grips).The hammer that came stock with this 2240 was notched and that's the one I used. All my previous 22xx's came without the notch."Old" style hammer on left, "new" notched hammer on the right.Here's the baseline string I ran before starting work with the SSG.Using 14.3gr CPHP, shooting approximately 1 shot every 20 seconds. Ambient temp was around 65 deg F.# Velocity FPE1. 364.4. 4.22. 364.0. 4.23. 362.7. 4.24. 361.2. 4.15. 359.8. 4.16. 362.3. 4.27. 365.1. 4.28. 366.4. 4.39. 367.0. 4.310. 363.0. 4.311. 369.5. 4.312. 364.7. 4.213. 365.0. 4.214. 370.3. 4.415. 365.0. 4.216. 362.3. 4.217. 355.9. 4.018. 353.8. 4.019. 349.5. 3.920. 345.3. 3.821. 340.2. 3.722. 337.1. 3.623. 337.0. 3.624. 333.6. 3.525. 329.2. 3.426. 317.7. 3.227. 299.3. 2.828. 279.4. 2.529. 254.6. 2.130. 224.0. 1.631. 186.6. 1.1Total FPE=114.3Here are the pictures of the SSG I used during testing. I had trouble getting the hole bored exactly in the center of the bolt which does leave some drag at certain positions when making adjustments. I'm currently working on a couple more SSG's and I hope to make future versions a little cleaner.The spring is from Ace Hardware's bin of compression springs (I can't be positive that the one in the picture above is the spring from the final setting). It started out longer and was clipped down during testing. It is (I think) a .025" wire with a smaller OD than "stock" (around 1/4" OD) clipped to 13 coils leaving an uncompressed length of approximately 1 3/8" and compressed under pre-load to 15/16". Gap was set to (approx) 1/16".Edit: added pictures of springTop spring is before clipping coils, bottom spring is the one used for the string I'm submitting.Trying to show the (smaller) OD of the spring usedShowing wire diameterHere's the string with the SSG:Again using 14.3gr CPHP, approx. 65*F, shooting approx. 1 shot per 15 seconds.# Velocity FPE1. 355.2. 3.962. 365.3. 4.233. 362.6. 4.184. 363.1. 4.185. 361.6. 4.166. 356.4. 4.027. 356.3. 4.028. 358.8. 4.099. 354.8. 4.010. 343.4. 3.7411. 348.9. 3.8712. 348.5. 3.8713. 347.3. 3.8214. 355.5. 4.0215. 350.9. 3.9116. 355.6. 4.0217. 356.8. 4.0518. 354.5. 4.019. 350.1. 3.8920. 357.1. 4.0521. 356.8. 4.0522. 359.1. 4.0923. 355.0. 4.024. 351.5. 3.9325. 354.2. 3.9826. 357.1. 4.0527. 354.7. 4.028. 356.0. 4.0229. 357.7. 4.0730. 362.0. 4.1631. 360.1. 4.1132. 355.8. 4.0233. 360.0. 4.1134. 348.2 3.8735. 348.2. 3.8536. 358.6. 4.0937. 362.1. 4.1638. 354.9 4.039. 360.6. 4.1440. 363.2. 4.1841. 359.0 4.0942. 358.0. 4.0743. 365.0. 4.2344. 364.5. 4.2345. 362.0. 4.1646. 364.6. 4.2347. 365.4. 4.2348. 365.1. 4.2349. 361.5. 4.1650. 366.9. 4.2851. 365.4. 4.2352. 365.1. 4.2353. 366.5. 4.2554. 366.0. 4.2555. 368.7. 4.3256. 361.6. 4.1657. 362.0. 4.1658. 365.4. 4.2359. 373.0. 4.4260. 366.9. 4.2861. 370.5. 4.3762. 367.0. 4.2863. 366.8. 4.2864. 367.1. 4.2865. 366.5. 4.2866. 368.2. 4.367. 366.5. 4.2868. 362.5. 4.1769. 366.8. 4.2870. 365.5. 4.2571. 367.1. 4.2872. 367.1. 4.2873. 368.2. 4.374. 368.0. 4.375. 366.1. 4.2576. 365.0. 4.2377. 366.3. 4.2578. 363.2. 4.1879. 366.5. 4.2880. 365.0. 4.2381. 365.4. 4.2382. 371.9. 4.3983. 370.8. 4.3784. 364.6. 4.2385. 359.4. 4.0986. 366.5. 4.2887. 368.2. 4.388. 367.1. 4.2889. 361.0. 4.1490. 359.0. 4.0991. 351.4. 3.9192. 352.0. 3.9393. 344.3. 3.7694. 338.3. 3.6395. 334.0. 3.5496. 323.9. 3.3397. 313.6. 3.1398. 309.8. 3.0599. 300.0. 2.86100. 290.1. 2.67101. 283.1. 2.54102. 270.2. 2.31103. 264.5. 2.23104. 261.3. 2.16105. 251.5. 2.02106. 245.0. 1.91107. 236.4. 1.77108. 228.0. 1.65109. 221.9. 1.56110. 212.4. 1.43111. 196.5. 1.23112. 182.4. 1.06113. 170.3. 0.92114. 161.1. 0.82115. 150.5. 0.72116. ERR. 0117. ERR. 0118. ERR. 0Total FPE=431.34I can't wait to see what other people have come up with.Thanks for the challenge Bob!Blue