Hi,DougIf you have your DragonClaw disassembled can you measured for me OD of the valve body (black aluminium body)I know is somewere around 20mm but I need more precise dimension.Thank you
That will buff out.
Tom, concentricity on the machined parts I'm not worried about, or for that matter the printed parts, just opened up the port as they tend to print holes a bit smaller than specified.I had goofed on my calculated length for the inner tubes and the felt lining hid that to a degree at least until I shot a few 10's of round thru it.New setup is 2/3 aluminum spacers and vented tubes an 1/3 printed baffles, took a couple of print to tweak everything to get it tight and lined up.