Quote from: bnowlin on June 04, 2015, 02:20:08 PMNice going, I think they are great. I do believe that is a special fitting on the compressor top and I don't believe it will take an foster fitting. Note where the washer is on the hose.BobIt's the same thread on the end of the hose fitting that also fits the male and female QC.~ GKU
Nice going, I think they are great. I do believe that is a special fitting on the compressor top and I don't believe it will take an foster fitting. Note where the washer is on the hose.Bob
Quote from: oneied on February 02, 2016, 08:19:43 AMQuote from: clgraham82 on February 02, 2016, 12:31:43 AMI went ahead and ordered the Omega...should be here Thursday! What are you doing with that Shoebow?!?!?!? I will be selling it (on here ) once I'm confident the Omega is going to get the job done.
Quote from: clgraham82 on February 02, 2016, 12:31:43 AMI went ahead and ordered the Omega...should be here Thursday! What are you doing with that Shoebow?!?!?!?
I went ahead and ordered the Omega...should be here Thursday!
Quote from: GKU on June 06, 2015, 03:45:20 AMQuote from: bnowlin on June 04, 2015, 02:20:08 PMNice going, I think they are great. I do believe that is a special fitting on the compressor top and I don't believe it will take an foster fitting. Note where the washer is on the hose.BobIt's the same thread on the end of the hose fitting that also fits the male and female QC.~ GKUGKUDid you go ahead and replace the supplied hose with the male foster fitting? Seems like a better idea than having the hose sticking up like that...would make it easier to use the cover without having to mod it.
About to pull the trigger on this. Any updates and or suggestions, good/bad??
SUGGEST looking at the HP check valve located on top dead enter of pump housing.My failed within the first 10 hours and was replaced with a self made replacement & been working fine ever sense !See: http://www.gatewaytoairguns.org/GTA/index.php?topic=102083.msg960133#msg960133
SUGGEST looking at the HP check valve located on top dead center of pump housing.My failed within the first 10 hours and was replaced with a self made replacement & been working fine ever sense !See: http://www.gatewaytoairguns.org/GTA/index.php?topic=102083.msg960133#msg960133Spell correction made
Very nice guy considering who he is dealing with. Dez are you using anything to dry the air going in the back and on high side. If not on the low side you might see some moisture in the check valve area. I built one out of pvc and I think Scott did tooBob