Any one know what the Set screw thread size that holds the Barrel ?? there are 2 of them (in the breach) I lost mine today while I was installing the quiet kit, if I knew the thread size , I will go to the hardware store tomorrow it's on the Kral puncher /breaker, thanks in advance, roger
Quote from: rdwilson on April 22, 2017, 11:42:38 PMAny one know what the Set screw thread size that holds the Barrel ?? there are 2 of them (in the breach) I lost mine today while I was installing the quiet kit, if I knew the thread size , I will go to the hardware store tomorrow it's on the Kral puncher /breaker, thanks in advance, rogerFront or rear screw? It's metric. I have an extra one that's closest to the the magazine.
The two screws are both the same thread but one is longer than the other. I would take the remaining screw to the hardware store and match it up.
I just took one of mine out and measured it. It is M6x1.0 and is 6mm long. This is the shorter of the two screws. Hope this helps.[/quoQuote from: elguapo99 on April 23, 2017, 11:43:54 AMI just took one of mine out and measured it. It is M6x1.0 and is 6mm long. This is the shorter of the two screws. Hope this helps..............THANK you very much, that is what I needed, now hopfully the hardware store has them , that was great what you did, roger
I just took one of mine out and measured it. It is M6x1.0 and is 6mm long. This is the shorter of the two screws. Hope this helps.
When I assembled mine, 3 baffles and the spring did not fill the shroud and were rattling around inside. I added the 4th baffle and the spring now has tension on it as it should.
For reference, the measurement on my gun from the small grub screw in the shroud to the front end of the shroud is 5" without the end cap screwed on. My Marauder baffles are each 1" long including the taper.
I received & installed Troy's kit today. The rifle is as quiet as my AT44 or Mrod now. Now I need to quiet down the pellet's impact! LOL I also was able to put 4 baffles in with the spring. Thanks Troy!Ed