Nice improvement in accuracy after the reg install and shroud. Good groups shooting at those big dots too.
Very nice work sir. The squirrels will NOT be happy...
That's very tidy work. Nicely done! Care to share a couple of bits of trivia? I'm curious what finish that was on the shroud, which coating and the manner in which it was applied. Is it a baked finish? Has a nice even matte quality. And you say the shroud is permanently affixed - I'm assuming likewise for the LDC? If so, how are they attached to the barrel?I've only installed one regulator, besides adjusting the one in my Ninja bottle after swapping the spring out for a stack of belleville spring washers. But I am very happy with my Robert Lane CO2/HPA conversion regulator which I had to turn down a few thousandths to fit inside my HiPAC, mounted on a 2240 carbine. My son's using that now for HFT and is delighted to get 40 shots with about a 1.5% ES, filling to just 2,200psi. Installation into the HiPAC was a bit trickier than a usual reg install but not that bad. The slight loss of fill volume is more than made up for by the improvement in consistency shot to shot.