All ready for FT practice. Just waiting on my bum bag.
Just ordered an AR20FT from WWAG. Just wondering. Are all Anschutz trigger blades the same? I would like to replace the trigger as well when it arrives. Champions Choice sells a replacement Anschutz trigger since they sell Anschutz products.
The next best thing that you can purchase for the Hammerli is one of the Clague muzzle devices that WWAG sells. They work a treat, and the effect is startling.
Quote from: chuckinohio on July 19, 2014, 02:16:57 AM The next best thing that you can purchase for the Hammerli is one of the Clague muzzle devices that WWAG sells. They work a treat, and the effect is startling.Yes. I also ordered the Claque LDC as well. Now I have to do the same type of mod as Josh. Drill and tap for a set screw when I get it. I wish WWAG would do it as an extra charge.
Gonzav,I have a MPR and it stacks pellets at 40 yards. I'm using it for FT. I just shot it sunday from 51 yards and I was grouping about 1in off my knee. I only shot one time at 50 and 55 yards to check my scope tape and I was getting ¼ in groups with ease. It is so accurate it was almost boring to shoot it from the bench. This gun gives me 70 shots with it a 13fps spread and 110 shots around 25 fps spread. For a non regulated gun that is fully stock I thought hat was very impressive.Regardless of the gun you shot, .177 pellets will be greatly affected by wind at the distances you want to shot. You can see the pellet being pushed by the wind. I shot Josh's AR20FT, and it is a very nice gun. Heavier than I would have expected. I found it a little uncomfortable but that is because it is set up for him. He would probably say the same thing about mine I can't speak for accuracy because I did not shot it long enough. Josh has done a great job with it. Per his comments, his gun is very loud without the LDC. I don't have one on my MPR but I don't think is that loud. I think it comes down to preference. I like wood stocks and not really interested on the AR20 look. I think you would not go wrong with either of them.
WWAG does drill and tap for the LDC. But that will add time to shipping. Im an impatient person, so i told them to send it as is, and did it myself. They do it free of charge if you order LDC with the Ar20.
Howdy...I have an AR20 & fill it with a Hill pump. What the trick is the AR20 tank has a fill adaptor that screws into the tube-unseating the valve. So one must be sure that the bleed valve on the fill unit-pump in my case-is closed. Fill the tank & when you want to remove the tank do not bleed down the fill line as normal. You just unscrew the cylinder. A small bit of air will escape but not much if done rapidly. Please note the gun will fire with the air tube disconnected entirely. There is enough left in the regulator to release a shot if not careful. Great gun-more accurate than I am by far.